VISSIM 5.30-05 User Manual

11 Evaluation Types for Simulations of Vehicles
The list below contains the set of parameters available, including the column
headers that will be used in the link evaluation output file.
Some parameters will only report correct results if the corresponding
optional module (such as Dynamic Assignment, Emission etc.) is installed.
Generally, current (short/long)distance/speed/acceleration units set via
VIEW - OPTIONS - [LANGUAGE & UNITS] are regarded for evaluation data output.
Emissions are always output in mg/m/s.
Parameter Definition Column Header
Density Vehicle density Density
Emissions Only with Emissions add-on: HC_evap
(Evaporation) HC Emissions (Evaporation)
Hydrocarbon in the current interval
Emissions Only with Emissions add-on: Bnzn
Benzene
Emissions Benzene during current
interval
Emissions CO Only with Emissions add-on:
Emissions CO during current
interval
CO
Emissions CO2 Only with Emissions add-on:
Emissions Carbondioxid during
current interval
CO2
Emissions HC Only with Emissions add-on:
Emissions HC during current
interval
HC
Emissions NMHC Only with Emissions add-on:
Emissions HC without Methane
during current interval
NMHC
Emissions NMOG Only with Emissions add-on:
Emissions Nonmethan Organic
Gasses during current interval
NMOG
Emissions NOx Only with Emissions add-on:
Emissions NOx during current
interval
NOx
Emissions Only with Emissions add-on: Particulate
Particulates Emissions Particulates during
current interval
Emissions SO2 Only with Emissions add-on:
Emissions Sulfurdioxide during
current interval
SO2
536 VISSIM 5.30-05 © PTV AG 2011