VISSIM 5.30-05 User Manual

12 Dynamic Assignment
Edge attributes:
● generated No.,
● vehicle type specific cost Value,
● Length
● Volume of the total flow for the
selected Time Interval
● Current Closures and the selected
vehicle type(s) are indicated.
Edge closures can be defined or discarded
via
● Edge closed (for the selected
edge)
● OPEN/CLOSE ALL EDGES buttons.
In the list, an edge can be selected for graphical display in the VISSIM
network.
Automatically created VISSIM edges are highlighted in the network display:
► Yellow = not closed or
► Red = closed for Dynamic Assignment
The paths shown in the window result
from the last iteration where the path file
was updated. The costs shown are
taken from the last cost file that was
written.
Thus the Edge Selection window only
then shows the results of the last
iteration, if both the cost and path files
were written during that iteration.
In the Edge selection window, the results of the recent iteration can only be
displayed if cost and path data was saved to *.BEW and *.WEG file during
this iteration.
610 VISSIM 5.30-05 © PTV AG 2011