VISSIM 5.30-05 User Manual

3 Program Handling
3.1.4 The VISSIM Status Bar: Data Output
The status bar is divided into three sections. Depending on the current
program mode each section displays different data:
Section 1 2D Graphics:
► Current cursor position (x, y coordinates in meters, “world
coordinates”)
3D Graphics:
► All modes except flight mode (only if not in any run mode):
Current position (x, y, z coordinates in meters) of that part
of the network, that is displayed at the center of the VISSIM
window at ground level.
► Flight mode: Current camera position (x, y, z coordinates in
[m]).
Section 2 Network editing:
► Number of selected link/connector
► Position within selected link/connector (if mouse is inside
selected link)
Simulation:
► Current simulation time and local cycle time
Cf. section 4.1.6: The default shortcut CTRL-U toggles
between the display types of the simulation time.
3D Graphics (Flight mode, not during simulation):
► Focal point position (the point the ‘plane’ is aiming for; x, y,
z coordinates in meters)
Section 3 Network editing:
► Editing instructions
Network editing (3D-Zoom, Rotate, Pan):
► Current observer position (d, A, C):
- d = distance (in meters) above level 0.0 m
- A = angle between XZ-plane and observer
- C = angle between XY-plane and observer
Simulation:
► Number of vehicles currently in the network
► Speed factor (actual simulation speed compared to real
time)
► In parentheses: Number of vehicles that could be simulated
at real time (displayed only if simulation speed = maximum)
► When command line parameter -s was used to start
VISSIM:
No. of current simulation run and (total number of runs).
46 VISSIM 5.30-05 © PTV AG 2011