VISSIM 5.30-05 User Manual

6 The Traffic Network
● NO LANE CHANGE...:
Define by lane whether the
vehicles of a vehicle class
may change to the neighboring
lane(s) located to the
LEFT and to the RIGHT in
with-flow direction.
Banned lane changes prevent any kind of lane change, even those due to
routes. Therefore be careful, please: See that lane changes due to routes
either can be finished before the no-lane-change section or can be
performed behind the no-lane-change section.
[DISPLAY] Parameters that change the appearance of the link (no influence on driving
behavior):
● Height (3D): Defines the z-coordinate of the start (Begin) and the End
point of the link to be visible in 3D graphics mode. The Height has no
effect on any driving behavior (it is independent of the gradient).
● Thickness (3D): Thickness of the bar representing the link in 3D graphics
mode.
● Recalculate Spline Point Height causes the intermediate (spline)
points of the link to always reflect a straight “height line” between the two
end points. Cf. section 6.3.1.3 for how to change the height of an
individual spline point.
188 VISSIM 5.30-05 © PTV AG 2011