VISSIM 5.30-05 User Manual

6 The Traffic Network
Select Single-select:
There are two ways to select a single link or connector:
► Right-click outside of the VISSIM network calls the Links/Connectors
selection list: Left-click to select a link or connector and click DELETE,
ZOOM or DATA).
► Left-click on the link or connector within the VISSIM network.
If multiple links/connectors overlap each other at the click position, the
button (default shortcut TAB) may be used to browse through all links
and connectors at the mouse click position in order to select the desired
one.
Multi-select (Only for Edit attributes, Move, Delete):
► There are three ways to define active links or connectors for further
editing in the multi-select mode:
- Draw polygon (cf. section 6.1) or
- Use Display type filter (cf. section 5.5.2) or
- Use Link behavior type filter (cf. section 5.5.1).
► Right-click outside of the VISSIM network to call the Link Attributes
(Multiselection) window for editing data of active links and connectors.
Move Single-select:
A connector can only be moved along with its start and destination link while
in Multi-Select-Mode (cf. section 3.3.2 for details).
► To change the connector position within the start or destination link:
1. Select the connector
2. Click on the desired start/end point and drag it with the mouse to the
desired location within the link.
► To change the start/end link of the connector:
1. Select the connector
2. Click on the desired start/end point and drag it with the mouse to the
desired location within the new link.
Multi-select:
1. Select links and connectors.
2. Left-click in the area of active elements and drag them to the desired
position while holding down the left mouse-key.
Moving the start/end points of a connector or moving the entire connector
from one link to another may break public and private transport routes.
Split Not possible for connectors.
198 VISSIM 5.30-05 © PTV AG 2011