VISSIM 5.30-05 User Manual

3 Program Handling
SELECTION Defines the edit mode in combination with the selected network element:
PEDESTRIAN
MODE
Single-select mode (Standard)
Multi-select mode
Label position mode. Any labels of network
elements (e.g. of signal heads) can be relocated
while the edit mode of that network element is
active.
If several links/connectors are located at the mouse
click position click this button to browse through all
these links/connectors.
42 VISSIM 5.30-05 © PTV AG 2011
TAB
Pedestrian mode add-on for modelling and simulation of pedestrian flows.
For the Pedestrian elements toolbar, please see below.
Toggles between vehicular and pedestrian traffic
mode.
SIMULATION The toolbar for SIMULATION run control is visible by default.
There are additional toolbars for ANIMATION or TEST runs. Furthermore there
is the RUN CONTROL toolbar which controls the most recently used run mode.
All of these additional toolbars are not visible by default.
Run simulation continuous F5
Run simulation one step further F6
Stop simulation ESC
NAVIGATION Commands for changing the observer position within the network.
Show entire network
Dynamic zoom (left click or mouse wheel),
Previous view (right click)
Zoom by factor
PAGE UP,
PAGE DOWN
Move network (3D only, shortcuts also in 2D) ,,,
Rotate network (3D only)
Fly through network (3D only)