SIREC D Display Recorder 7ND4000

Operation
C. Bypass Point - This menu item removes
active points from the measurement cycle. A
bypassed point will still be in the database and the
message BYPASSED will display when the
bypassed point appears on the display or is
printed. To Bypass a point or points, use the
following instructions and Figure 3-34:
1. Press the FUNCTION Key and use the UP (↑)
or DOWN (↓) Arrow Keys to highlight “Bypass
pt”.
2. Press ENTER and the pop-up display will read
“point? X”.
3. Use the numeric keypad to enter the point to
bypass and press ENTER. The display will then
scroll to the next point in sequence.
4. Use the above procedure to bypass any additional
points. When finished, press EXIT to return
to the “Bypass pt” menu display.
103724MA
3-18
ENTER
ENTER
04/16/97 4:59:29
04/16/97 4:59:29
A
B
C
P oint? 1
7 8 9
4 5 6
3 2 1
04/16/97 4:59:29 EXIT
Figure 3-34 Bypass Points Flow Chart
D. Reset Point - This function forces a reset for
Resettable Point Types. The value of the following
types of calculated points may be reset:
• Time Average Resets data to the current
value of the base point
• High Peak Resets data to the current
value of the base point
• Low Peak Resets data to the current
value of the base point
• Totalize Resets to zero
1. Press the FUNCTION Key at the “COMMAND”
prompt and use the UP (↑) or DOWN (↓) Arrow
Keys to highlight “Reset pt”.
2. Press ENTER and the display reads “point?
X”.
3. Use the numeric keypad to select the point to
reset. Press ENTER and the next sequential
point will be displayed.
4. When resetting points is complete, press EXIT
to return to the “Reset pt” menu item.
103725MA
ENTER
ENTER
04/16/97 4:59:29
04/16/97 4:59:29
04/16/97 4:59:29
A
B
C
Point? 1
7 8 9
4 5 6
3 2 1
04/16/97 4:59:29 EXIT
Figure 3-35 Reset Point Flow Chart
Siemens AG C79000-G7374-C211-01
SIREC D Manual