SIREC D Display Recorder 7ND4000
SIREC D Display Recorder 7ND4000
SIREC D Display Recorder 7ND4000
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
I. Trend Message - This menu item is used to<br />
manually print one of the six Event Messages (refer<br />
to Chapter 4) to the Alarm / Events Window and<br />
Alarm file. To select an Event Message, perform<br />
the following steps and refer to Figure 3-40:<br />
104026MA<br />
1 XXXXXX<br />
04/16/97 4:59:29<br />
04/16/97 4:59:29<br />
04/16/97 4:59:29<br />
Figure 3-40 Select Message to <strong>Display</strong> Flow<br />
Chart<br />
1. Press the FUNCTION Key at the “COMMAND”<br />
prompt and use the UP (↑) or DOWN (↓) Arrow<br />
Keys to highlight “Trnd Message”. Press ENTER<br />
and “1 XXXX” will display where 1 is Event message<br />
1 and XXXX is the Event message that will<br />
print.<br />
2. Use the UP (↑) or DOWN (↓) Arrow Keys to<br />
select the correct Event message and press<br />
ENTER. The display will return to the “Trnd Message”<br />
menu item and the Event entry will be<br />
made.<br />
Siemens AG C79000-G7374-C211-01<br />
<strong>SIREC</strong> D Manual<br />
Operation<br />
3.5.5 Hidden Menu. The Hidden menu<br />
allows you to do the following functions:<br />
• Initialize<br />
• ADC Control<br />
• Diagnostics<br />
The Hidden menu can only be accessed by<br />
pressing the MENU key immediately followed by<br />
pressing the upper right-hand corner of the<br />
display. This is the only combination that will work.<br />
A. Initialize - The Initialize Menu allows you to<br />
perform the following:<br />
• Init Profile<br />
• Clear Points<br />
• Erase Config<br />
CAUTION<br />
USE OF THE ABOVE MENU ITEMS WILL<br />
CLEAR SYSTEM CONFIGURATION.<br />
REFER TO CHAPTER 4 FOR AN<br />
EXPLANATION OF THE FOLLOWING<br />
MENU OPTIONS.<br />
1. Instructions - To initialize the unit, use the UP<br />
(↑) or DOWN (↓) Arrow Keys to highlight “Initialize”<br />
from the Hidden menu and press ENTER.<br />
There are three choices:<br />
a. Init Profile - Perform a Smart or Full Initialization<br />
by selecting this Menu Item and<br />
pressing ENTER. Refer to Paragraph 3.2.2.D<br />
for details.<br />
b. Clear Points - Restore all points to the unprogrammed<br />
state. This will clear any invalid<br />
setup data.<br />
c. Erase Config - Set all data to zero, clear all<br />
memory. USE WITH CAUTION! Will cause the<br />
unit to RESET.<br />
2. Use the UP (↑) or DOWN (↓) Arrow Keys to<br />
highlight the menu item of choice and press<br />
ENTER. Proceed with caution. Note that any<br />
cleared point can be restored in the Point setup<br />
menu.<br />
3-21