OneSight Administrator Guide

Modifying a Monitor Group
Check All – Selects all monitors.
Uncheck All – Deselects all monitors.
Check Box – The check box adjacent to each monitor controls
whether or not the monitor is currently in effect. When selected,
the monitor is enabled. When cleared, the monitor is disabled.
Disabled monitors will not contribute to the measurement of the
monitor group’s health.
Monitors Settings – Lists by name the types of monitors that are
configured for the current monitor group.
Name – The Name column usually identifies the monitor type
and the machine, server, or host that is being monitored. You
can specify a name when you add the monitor to the monitor
group.
The Monitor Group Editor has the following tabs for
configuring the monitor group:
Monitors – Shows all of the monitors that are in effect for the
current monitor group. Use options on the Monitors tab to
add, modify, or remove monitors for your monitor group.
You can also enable or disable individual monitors.
Status Chart – Use options on this tab to specify which
monitor should display on the OneSight Status page as
charted data for this monitor group.
Health – Use options on this tab to set up an action plan that
is triggered when the monitor group goes into a Warning
state, an action plan that is triggered when the monitor group
goes into a Critical state, and an action plan that is triggered
when the monitor group returns to a Good state.
For web farm management, settings are available that allow
you to group a single profile monitor type and specify how
Chapter 4: Configuring Monitor Groups 93