OneSight Administrator Guide

Configuring the VQ Inspector Monitor for the Avaya Communication Manager
Called Number Start Index and Length – Enter the called
number start index and length.
Calling Number Start Index and Length – Enter the calling
number start index and length.
Sample Every: – Specifies how often samples are
taken for this monitor. Refer to, ―Sample Every Settings,‖ later
in this chapter for a description of these settings.
3. Enter the IP Address of the Avaya Communication Manager.
4. Select the SNMP version being used.
5. Enter the CDR configuration. You must restart the Data
Collector for the changes to take effect.
6. Enter the sampling rate.
7. Click the Location tab.
8. Select a specific named location to use for data collecting.
Note: Because the Data Collector must listen on specific ports
for incoming RTCP and Call Detail Records, the Avaya
Communication Manager monitor must use one specific, named
location for data collection. The location should not
be used.
In addition, only one data collector should be installed on the
data collector machine.
9. To verify that the monitor will work as configured, click the
Test button. The Monitor Test window provides information
about the success or failure of the test and indicates what may
be causing any problem.
10. If the test succeeds, click OK in the Add Monitor dialog box to
save these settings. You can now add this monitor to a monitor
128 OneSight Administrator Guide