OneSight Administrator Guide

Configuring the Cisco Call Manager Profile Monitor
Auth/Priv – Both Authentication and privileges.
User Name – Enter the user name to use to log in to the SNMP
version 3 protocol.
Password – Enter the password to use to log in to the SNMP
aversion 3 protocol.
Auth – Select the authentication hashing function to use: MD5
or SHA.
Privacy Mode – Select the method to use for encrypting the
data.
Privacy Password – If you have selected a privacy mode,
enter the password.
Context – Enter the context setting that matches the setting in
the device that is being monitored. Typically, it is a name that
describes the device. For example, ―bridge.‖
Time Out – The amount of time, in seconds, to wait for data
from the Cisco Call Manager before timing out.
Port – Specifies the port number used on this system by the
SNMP agent. Typically, this is port 161.
Connection Method – Select the connection method to use.
User Name – Enter the user name to use to log in to the Cisco
Call Manager.
Prompt – Specify the command line prompt for the Cisco Call
Manager.
Sample Every: – Specifies how often samples are
taken for this monitor. Refer to, ―Sample Every Settings,‖ later
in this chapter for a description of these settings.
150 OneSight Administrator Guide