OneSight Administrator Guide

Configuring OneSight Probe Monitors
9. Click OK in the Add Monitor dialog box to save these basic
OneSight Call Statistics Profile monitor settings. You can now
add this monitor to a monitor group. Refer to Adding Monitors
to a Monitor Group in Chapter 4.
Configuring OneSight Probe Monitors
The OneSight Probe monitor uses a customer created probe,
referred to as a self-describing probe (SDP) as a data source for
reporting information for monitoring. The SDP allows unrestricted
collection of information for metrics that are not known to
OneSight. Refer to the OneSight Probe Reference Manual for
details on creating an SDP.
In the Add Monitor dialog box, when you click OneSight Probe in
the Monitor Types box, settings to configure a OneSight Probe
monitor appear on these dialog box tabs:
General Tab – Contains the options that you can use to create a
OneSight Probe monitor.
Alerts Tab – Shows what action plan will be used when an alert
occurs. Options on this tab allow you to set up or modify an action
plan that responds to alerts generated by the current OneSight Probe
monitor. You can also configure how an alert will affect the
monitor group’s health. It can result in a Warning state, a Critical
state, or can have no impact on health.
SmartLinks Tab – Contains the options for specifying a link to
associate with a particular monitor or metric.
Attributes Tab – Contains the options for specifying which attributes
are applied to this monitor for Status page sorting.
Monitor Groups Tab – Contains the options that you can use to
specify which monitor groups the monitor is used with. This tab is
available when you open the Add Monitor window by selecting
Chapter 5: Configuring Monitors 201