OneSight Administrator Guide

Modifying the Location of Multiple Monitors
location(s) have a disabled checkbox since the location cannot
be removed from a monitor that is not using the location.
Check All – Checks all monitors in the list that do not have a
disabled check box..
Uncheck All – Unchecks all monitors in the list.
Save Changes – Saves the changes. This may take several
minutes.
Check box – Indicates which monitors are available for
selection and which monitors are selected. Selected monitors
will have the changes applied to them. The monitors that are
available for selection are determined by which tab you are in:
Add Locations – Monitors that already use all of the selected
locations will have a disabled check box. Monitors that do
not support using more than one location will have a disabled
check box.
Change Locations – Monitors that already use all of the
selected locations will have a disabled check box. Monitors
that do not support using more than one location will have a
disabled check box if more than one location has been
selected in the Selected Locations field.
Remove Locations – Monitors not using the selected
location(s) will have a disabled check box. In addition,
monitors that will result in zero locations after the removal,
that is, the only location assigned to the monitor is the
selected location, will have a disabled check box.
Note: Monitors that do not allow a location to be selected
when the monitor is created will have a disabled check box.
Monitor Name – Displays the monitor name. Click in the column
header to sort the list. An arrow is displayed showing the
direction of the sort, ascending or descending.
484 OneSight Administrator Guide