OneSight Administrator Guide

Critical State Error Messages
5. Enter the new password.
6. Go back to the Status page and click the monitor group of the
system.
7. Click the Enabled checkbox to disable the monitor.
8. Click the Disabled checkbox to enable the monitor and wait for
the metrics to resample.
Remote procedure call failed (Windows only)
This error message may occur when OneSight had trouble reauthenticating
its connection with the system after the system was
rebooted. While viewing the monitor on the status page, click the
Enabled button to disable the monitor. The monitor will move to the
bottom of the list in the monitor group. Click the Enabled button to
enable the monitor, forcing OneSight to re-authenticate with the
system.
Failed to load Perfmon name table (Windows only)
This error message may occur when OneSight had trouble reauthenticating
its connection with the system after the system was
rebooted. While viewing the monitor on the status page, click the
Enabled button to disable the monitor. The monitor will move to the
bottom of the list in the monitor group. Click the Enabled button to
enable the monitor, forcing OneSight to re-authenticate with the
system.
Missing counter value (Windows only)
This message occurs when the indicated Windows perfmon metric
does not exist on this system. In most cases, this is a system process
that has stopped running. To resolve this problem:
1. Log onto the system that is displaying the error message.
2. From the Start menu, click Run and enter perfmon.
920 OneSight Administrator Guide