OneSight Administrator Guide

Configuring OneSight Voice Watch Monitors
User ID – Type the User ID of your OneSight Voice Watch
service account.
Password – Type the password of your OneSight Voice Watch
service account.
Server – Enter the name or IP address of the OneSight Voice
Watch server.
Get Voice Watch Monitors – After you provide the account
information (User ID, Password), click Get Voice Watch
Monitors to retrieve the active monitors configured in your
OneSight Voice Watch service account. If you have previously
specified this account information, these monitors will be
retrieved automatically.
Monitors – After you click Get Voice Watch Monitors, the active
monitors configured in your OneSight Voice Watch service
account will be displayed in this list box.
Measurement – The steps available for the monitor are listed.
Sample Every: – Specifies how often samples are
taken for this monitor. Refer to, ―Sample Every Settings,‖ later
in this chapter for a description of these settings.
Test – When you add or modify a monitor, you can test settings
to determine if they are set appropriately. After clicking the
Test button, you will see messages in the status window as the
test runs and when the test completes.
3. Each monitor that you add must have a unique name. You can
let OneSight create a unique name using the OneSight Voice
Watch specifications you supply, or you can type in your own
name for the monitor.
4. On the General tab in the User ID box, type the name of your
OneSight Voice Watch User ID.
228 OneSight Administrator Guide