OneSight Administrator Guide

Editing VQ Probes
Note: The VQ Probe should use static IPs per channel. If the IP
address should change, reopen the configuration for the probe and
save it.
To configure a VQ Probe:
1. Click the Configure menu.
2. Click VQ Probes.
This dialog box shows a list of connected VQ Probes. OneSight
automatically adds VQ Probes to the list and remembers them
even if they disconnect.
Modify – Displays the VQ Probe Editor for modifying the
configuration package associated with this probe.
Remove – Removes the selected VQ Probe from the list. Probes
can only be removed if they are not connected to OneSight and
if they are not being used by any monitors, including disabled
monitors. If the probe is still connected to OneSight, OneSight
will add the probe back to the list.
872 OneSight Administrator Guide