OneSight Administrator Guide

Specifying the Status Chart Data Source
If you select a profile monitor, you can specify which metric
within that profile should be used to supply data for the monitor
group status chart.
Note: If the monitor name contains the following special
characters, they will not be displayed in the name in the drop
down list: “”, and “&”.
Derive Status Chart Data From Metric – The list shows all of the
metrics available for the selected monitor. Select the metric you
want to use for the status chart.
If you selected a dedicated monitor in the Derive Status Chart
Data From Monitor list, the Derive Status Chart Data From Metric
setting is unavailable. For dedicated monitors, only a single
metric source is available to supply data for the status chart.
2. Select a monitor in the Derive Status Chart Data From Monitor
list.
The Monitors list shows all of the monitors that are currently
set up for this monitor group. Information collected by the
monitor that is selected will be displayed on the OneSight
Status page as charted data.
If you select a profile monitor, use the Derive Status Chart Data
From Metric setting to specify which metric within that system
monitor profile should be used to supply data for the monitor
group status chart.
If you select a dedicated monitor, the Derive Status Chart Data
From Metric setting is unavailable. For dedicated monitors, only
a single metric source is available to supply data for the status
chart.
3. If you chose to derive data from a profile monitor, select one of
the profile’s metrics in the Derive Status Chart Data From
Metric list.
Chapter 4: Configuring Monitor Groups 97