OneSight Administrator Guide

Editing VQ Probes
Username – Enter the user name that all probes will use to
authenticate to the PBX. Leave this field blank if
authentication is not required.
Password – Enter the password that all probes will use to
authenticate to the PBX. Leave this field blank if
authentication is not required.
Unique network ID – Enter the four digit network ID of the
endpoint. This field is used to respond to the server when the
server queries the endpoint’s location information.
Manufacturer ID – Enter the two digit unique manufacturer ID
of the endpoint.
Firmware Version – Enter the firmware version code of the
endpoint.
7. Enter the configuration information for this probe and click
Save.
Configuring a VQ Probe on a G5 or FX/TDM System
VQ Probes can be configured on Hammer systems or non-Hammer
systems. The configuration screens are not the same. This section
describes how to configure a VQ Probe on a Hammer system. Refer
to “Configuring a VQ Probe,” earlier in this chapter for
information on configuring VQ Probes on a non-Hammer system.
To configure a VQ Probe on a G5 or FX/TDM System:
1. Click the Configure menu.
880 OneSight Administrator Guide