OneSight Administrator Guide

Editing VQ Probes
6. In the tree, select the channel group that you want to configure.
General
Protocol – Select the protocol to use. The type of protocol
determines which fields are displayed in the Configuration
section of this dialog box.
Note: UNIStim is only supported for probe to probe calling. It
is not supported for Hammer to probe calling.
IP Address – Enter the local IP address that the VQ Probe will
use to originate calls, and listen on for incoming messages
and connections.
Select the starting IP address for each channel group. Each
channel in the group will use the next incremental IP address.
A unique IP address must be associated with each station
extension. You must manually add your IP addresses to the
Chapter 16: Configuring VQ Probes 875