OneSight Administrator Guide

Editing a Response to an Alert – Dedicated Monitor
For , enter the number of sample counts that must be ―bad‖
before OneSight triggers a response. For , enter a total
number (a count) of samples. The value of must be a
number less than or equal to .
7. Click OK to exit the Alert Editor and return to the Add Monitor
dialog box. The alert you defined appears in the Alerts list.
To define a response for a dedicated monitor:
1. In the Add Monitor dialog box or the Monitor Configuration
dialog box, click the Alerts tab.
2. If you are adding a new alert, click Add, define the alert
condition and then proceed with the steps listed below. If you
are modifying an existing alert, select it and click Modify.
3. In the Respond By list, select an action plan or click to create one.
4. In the Apply To list, if available, select how the alert should
affect the monitor’s health. For example, if the Sample Failure
occurs, decide if the monitor should be set to a Warning state
(the monitor will turn yellow on the Status page), a Critical
state (the monitor status will turn red), or Nothing (no change in
monitor status).
Note: The Apply To setting is not available if Respond If is set to
Greater Than Threshold (Notify Repeatedly) or Less Than
Threshold (Notify Repeatedly).
448 OneSight Administrator Guide