ITT - Index of

ITT5453, ITT5454, ITT7453, ITT7454
. EXPANDABLE 4-WIDE 2-INPUT AND-DR-INVERT GATES
ELECTRICAL CHARACTERISTICS over recommended operating free-air temperature range
(unless otherwise noted)
Parameter Min Typ' Max Unit Test Conditions 2
Vin(l) Logical 1 input voltage required 2 V
at both input terminals of one
AN D section to ensure logical 0
level at output
Vin(O) Logical 0 inp ut voltage required 0.8 V
at one input terminal of each
AND section to ensure logical 1
level at output
VI Input Clamp Voltage -1.5 V VCC = Min Ii = -12mA
V out(l) Logical 1 output voltage 2.4 3.3 V VCC = MIN. Vin = 0.8V
I!oad= -400 uA
Vout(O) Logical 0 output voltage 0.22 0.4 V VCC = MIN. Vin = 2V.
Isink = 16mA
lin(O) Logical 0 level input current -1.6 mA Vcc· = MAX. Vin = 0.4V
(each input)
lin(1 ) Logical 1 level input current 40 uA VCC = MAX. Vin = 2.4V
(each input)
1 mA VCC = MAX. Vin = 5.5V
lOS Short-circuit output current 3 -20 -55 mA VCC = 5.5V IITT5453.ITT5454
-18 -55 IITT7453.ITT7454
ICC(O) Logical 0 level supply current 5.1 9.5 mA VCC = MAX. Vin = 5V
ICC(1 ) Logical 1 level supply current 8 mA VCC = MAX. Vin = 0
, All typical values are at V CC = 5V. T A = 25°C.
2 For conditions shown as MIN or MAX. use the appropriate value specified under recommended operating conditions
for the applicable device type. Expander inputs X and X are open.
3 Not more than one output should be shorted at a time .
. ELECTRICAL CHARACTERISTICS (lTT5453 circuits) using expander inputs.
Vee = 4.5V. TA = -55°e
----- .. - .•.. - -
Parameter Min Typ' Max Unit Test Conditions 2
Ix Expander current 2.9 mA VI = 0.4V. Isink = 16mA
VBE(Q) Base-emitter voltage of output 1.1 V Isink = 16mA.li = 0.41mA.
transistor (Q) Rl =0
Vout(l) Logical 1 output voltage 2.4 3.3 V Iload = -400 uA.
11 = 0.15mA.12 = -0.15mA
Vout(O) Logical 0 output voltage 0.22 0.4 V Isink = 16mA. 11 = 0.3mA.
Rl = 138 n
3-85