ITT - Index of

ITT5486, ITT7486
QUADRUPLE 2-INPUT EXCLUSIVE-OR GATES
ELECTRICAL CHARACTERISTICS. over recommended operating free-air temperature range
(unless otherwise noted)
ITT5486
ITT7486
Parameter Min Typ' Max Min Typ' Max Unit Test Conditions 2
VIH High-level input 2 2 V
voltage
VIL Low-level input 0.8 0.8 V
voltage
VI I nput clamp voltage -1.5 -1.5 V Vee = MIN, II = -8 mA
V OH High-level output 2.4 3.4 2.4 3.4 V Vee = MIN, VIH = 2V,
voltage
VIL = 0.8V, 10H = -800 uA
VOL Low-level output 0.2 0.4 0.2 0.4 V Vee = MIN, VIH = 2V,
voltage
VIL = 0.8V, 10L = 16 mA
II Input current at 1 1 mA Vee = MAX. VI = 5.5V
maximum input
voltage
IIH High-level input 40 40 uA Vee = MAX, VI = 2.4V
current
IlL Low-level input -1.6 -1.6 mA Vee = MAX. VI = O.4V
current
lOS Short-circuit output -20 -55 -18 -55 mA Vee = MAX
current 3
ICC Supply current 30 43 30 50 mA Vee = MAX, See Note 2
, All typical values are at Vee = 5V. T A = 25°C.
2 Fo rconditions shown as MI N or MAX, use the appropriate value specified under recommended operating conditions
forthe applicable type.
3 Not more than one output should be shorted at a time.
Note:
2. ICC is measured with the inputs grounded and the outputs open.
SWITCHING CHARACTERISTICS. Vee = 5V. TA = 25°e
From
Parameter' (Input) Min Typ Max Unit Test Conditions
tpLH Aor B 15 23 ns Other input low
e L = 15 pF. RL = 400Jl
tpHL AorB 11 17 ns Other mput low
e L = 15pF.
RL = 400n
tpLH Aor 8 18 30 ns Other input high
e L = 15 pF, RL = 400Sl.
tpHL Aor B 13 22 ns Other input high
-
e L = 15 pF. RL = 400Sl.
, tPLH = propagation delay time, low-to-hig h-Ievel output. tpHL - propagation delay time. hlgh-to-Iow-Ievel output
3-121