ITT - Index of

ITT54195, ITT74195
4-81T PARALLEL-ACCESS SHI FT REG ISTERS
ELECTRICAL CHARACTERISTICS over recommended operating free-air temperature range
(unless otherwise noted)
Parameter Min Typ' Max Unit Test Conditions 2
VIH High-level input voltage 2 V
VIL Low-level input voltage 0.8 V
VI Inpllt clamp voltage -1.5 V Vee = MIN. II = -12mA
VOH H igh'level output voltage 2.4 V Vee = MIN. VIH = 2V.
VIL = 0.8V. 10H = -800uA
VOL Low-level output voltage OA V Vee = MIN. VIH = 2V.
VIL =0.8V.IOL = 16mA
II Input current at maximum input 1 mA Vee = MAX. VI = 5.5V
voltage
IIH High-level input current 40 uA Vee = MAX. VI = 2.4V
IlL Low-level input current -1.6 mA Vee = MAX. VI ~ OAV
lOS Short-circuit output current 3 -20 -57 mA Vee = MAX IITT54195
-18 -57
llTT74195
lee Supply current 39 63 mA Vee = MAX. See Note 2
Note:
2. With all outputs open. shift/load grounded, and 4.5V applied to the J, K, and data inputs, lee is measured
by applying a momentary ground, followed by 4.5V, to clear, and then applying a momentary ground, followed
by 4.5V, to clock.
, All typical values are at Vee = 5V, T A = 25°e.
2 For conditions shown as M IN or MAX, use the appropriate value specified under recommended operating conditions
for the applicable device type.
3 Not more than one output should be shorted at & time.
SWITCHING CHARACTERISTICS. Vee = 5V, TA = 25°e, N = 10
.
Parameter Min Typ Max Unit Test Conditions
fmax Maximum input clock frequency 30 39 MHz eL = 15pF, RL = 400.n.
tpHL Propagation delay time, 19 30 ns eL = 15pF, RL = 40011
high-to-Iow-Ievel output from
clear
tpLH Propagation delay time, 6 14 22 ns eL = 15pF, RL = 40011
low-to-high-Ievel output from
clock
tpHL Propagation delay time, 7 17 26 ns eL = 15pF, RL = 400.n.
high-to-Iow-Ievel output from
clock
3-244