ITT - Index of

ITT5495A. ITT7495A
4-811 RIGHT-SHIFT !-EFT-SHIFT REGISTERS
ELECTRICAL CHARACTERISTICS over recommended operating free-air temperature range
(unless otherwise noted)
Parameter Min Typ' Max Unit Test Conditions 2
Vin(l) Input voltage required to ensure 2 V
logical 1 at any input terminal
Vin(O) I nput voltage required to ensure 0.8 V
logical 0 at any input terminal
V1 Input Clamp Voltage -1.5 V Vee = Min Ii = -12mA
Vout(l) Logical' 1 output voltage 2.4 V Vee = MIN. Iload =-800uA
Vout(O) Logical 0 output voltage 0.4 V Vee = MIN. Isink = 16mA
lin(O) Logical 0 level input current at -1.6 mA Vee = MAX. Vin = 0.4V
any input except mode control
lin(O) Logical 0 level input current at ' -3.2 mA Vee = MAX. Vin = 0.4V
mode control
lin(l ) Logical 1 level input current at: 40 ua Vee = MAX,Vin = 2.4V
any input except mode control
1 mA Vee = MAX. Vin = 5.5V
lin(1) Logical 1 level input ,current at 80 uA Vee = MAX. Vin = 2.4V
mode control
~ ~;.
1 mA Vee = MAX. Vin = 5.5V
lOS Short-circ4(t output current 3 -18 -57 mA Vee = MAX
ICC Supply current 39 63 mA Vee = MAX
SWITCHING CHARACTERISTICS. Vee = 5V.TA = 25°e. N = 10
Parameter Min Typ Max Unit Test Conditions
fmax Maximum shift frequency 25 36 MHz eL = 15 pF. RL = 4000
tpdl
Propagation delay time to logical
1 level from clock 1 or clock 2
to outputs
18 27 ns eL=15pF.R L =400n
tpdO Propagation delay time to logical 21 32 ns eL = 15 pF. RL = 4000
o level frol1l'Clock 1 or clock 2
to outputs,,:,
, All typical va lues are at Vee = 5V. T A = 25° e. , ,:
2 For conditions shown as M IN or MAX. use the appropriate value specified under recommended operating conditions
for the particular circuit type.' ,
3 Not more than one output should be shorted at a time.
3-140