ITT - Index of

ITT5413,ITT7413
DUAL NAND SCHMITT TRIGGERS
ELECTRICAL CHARACTERISTICS over recommended operat.ing free-air temperature range
(unless otherwise noted)
Parameter Min Typ' Max Unit· Test Conditions 2
VT+ Positive-going threshold voltage 1.5 1.7 2 V Vee = 5V
VT- Negative-going threshold 0.6 0.9 1.1 V Vee = 5V
voltage
VT+ Hysteresis 0.4 0:8 V Vee - 5V
-VT-
VI I nput clamp voltage -1.5 V Vee = MIN.II = -12mA
VOH High-level output voltage 2.4 3.3 V Vee = MIN. VI = 0.6V
IOH =. -800 uA
VOL Low-level output voltage 0.22 0.4 V Vee = MIN. VI = 2V.
IOL = 16 mA
IT+ Input current at positive-going -0.65 mA Vee = 5V. VI = VT+
threshold
IT- Input current at negative-going -0.85 mA Vee = 5V. VI = VTthreshold
II Input current at maximum input 1 mA Vee = MAX. VI = 5.5V
voltage
IIH High-level input current 40 ).lA Vee = MAX. VI = 2.4V
IlL Low-level input current -1 -1.6 mA Vee = MAX. VI = 0.4V
lOS Short-circuit output current 3 -18 -55 mA Vee = MAX
leeH Supply current. high-level output 14 23 mA Vee = MAX. VI = 0
leeL Supply current. low- level output 20 32 mA Vee = MAX. VI = 4.5V
SWITCHING CHARACTERISTICS. Vee = 5V. TA = 25°e. N =.10
Parameter Min Typ Max Unit Test Conditions
tpLH Propagation delay time. 18 27 ns eL = 15pF.RL =400Q
low-to-high-Ieveloutput
tpHL Propagation delay time. 15 22 ns eL = 15pF.RL =400Q
high-to-Iow-Ieveloutput
, All typical values are at Vee = 5V. T A = 25°e.
2 For conditions shown as MIN or MAX. use the appropriate value specified under recommended operating conditions
for the applicable device type.
3 Not more than one output should be shorted at a time.
3-42