ITT - Index of

ITT5432, ITT7432
QUADRUPLE 2-INPUT POSITIVE-OR GATES
ELECTRICAL CHARACTERISTICS over reoommended operating free-air temperature range
(unless otherwise noted)
Parameter· Min Typ' Max Unit Test Conditions 2
VIH High-level input voltage 2 V
Vil low-level input voltage 0.8 V
VI Input clamp voltage -1.5 V VCC = MAX. II = -12mA
VOH High-level output voltage 2.4 3.3 V VCC = MIN. VIH = 2V.
10H = -800uA
Val low-level output voltage 0.22 0.4 V VCC = MIN, Vil = 0.8V,
10l = 16mA
II Input current at maximu m input 1 rnA VCC = MAX, VI = 5.5V
voltage
•
I
IIH High-level input current 40 uA Vce = MAX, VI = 2AV
III low-level input current -1.6 rnA VCC = MAX, VI = OAV
lOS Short-circuit output current 3 -20 -55 rnA VCC = MAX ITT5432
-18 -55 ITT7432
ICCH Supply current. high-level output 15 22 mA VCC = MAX, See Note 2
ICCl Supply current. low-level output 23 38 rnA VCC = MAX, See Note 3
, All typical values are at V CC = 5V, TA = 25°C.
2 Forconditionsshown as MIN or MAX, use the appropriate value specified under recommended operating conditions
for the applicable device type.
3 Not more than one output should be shorted at a time.
Notes:
2. ICCH is measured with one input of each gate at 4.5V, the remaining inputs grounded, and outputs open.
3. ICCl is measured with both inputs of all gates grounded, and outputs open.
SWITCHING CHARACTERISTICS. Vee = 5V, TA = 25°e, N = 10
Parameter Min Typ Max Unit Test Conditions
tpHl Propagation delay time, 14 22 ns Cl = 15 pF, Rl = 40o-nhigh-to-Iow-Ieveloutput
tplH Propagation delay time, 10 15 ns Cl = 15 pF, R l = 40o-nlow-to-high-Ieveloutput
3-57