SIMPLORER User Manual V6.0 - FER-a

Component Outputs
SIMPLORER 6.0 — Manual 91
Description [Unit] Parameter Name Data Type
Voltage [V] V real
Current [A] I real
Source Current [V] IS real
Derivative of Voltage [V/s] dV real
Derivative of Current [A/s] dI real
Component Nodes
Description Node Name Nature
Pin 1 (with red point) N1 electrical
Pin 2 N2 electrical
Time-Controlled Linear Current Source
it () =
f[ time function]
The time controlled current sources have the same properties as the linear current source
above. The voltage of an ideal current source is arbitrary. The value of the source current instead
is equivalent to the present value of the selected time function at each calculation step.
The simulator internal names of time controlled current sources read as follows: Sine – ISINE;
Pulse – IPULSE; Triangular – ITRIANG; Trapezoidal – ITRAPEZ; Saw-tooth Rising –
ISZ_RISE; Saw-tooth Falling – IST_FALL. The names only relevant to simulation scripts in
SML. Access to source parameters is carried out only by the component name.
Component Parameters
Description [Unit] Parameter Name Data Type
Amplitude [A] AMPL real
Frequency [Hz] (no trapezoidal function parameter) FREQU real
Period [s] TPERIO real
Delay [s] TDELAY real
Phase [deg] PHASE real
Angular Dimension n/a
Offset [A] OFF real
Periodical; PERIO=1, peridical function, PERIO=0; non-periodical
function
PERIO real
Rise Time [s] (only trapezoidal function) TRISE real
Fall Time [s] (only trapezoidal function) TFALL real
Pulse Width [s] (only trapezoidal function) PWIDTH real
EMF Magnitude [A] AC_MAG real
EMF Phase Shift [deg] AC_PHASE real