SIMPLORER User Manual V6.0 - FER-a

4
5
84 Modeling with Circuit Components
4.2 Sources
Component Parameters
Description [Unit] Parameter Name Data Type
Inductance L1 [H] L1 real
Inductance L2 [H] L2 real
Coupling Factor [/] K real
Component Outputs
Description [Unit] Parameter Name Data Type
Mutual Inductance [H] M real
• Voltage Source
(E/ESINE/ETRIANG/EPULSE/EST_FALL/ESZ_RISE/ETRAPEZ)
• Controlled Voltage Source (EV/EVNL/EI/EINL)
• Current Source
(I/ISINE/ITRIANG/IPULSE/IST_FALL/IST_RISE/ITRAPEZ)
• Controlled Current Source (I/IV/IVNL/II/IINL/ICNL)
• Voltage Controlled Oscillator (EVCO/IVCO)
• Polynomial Source (EPOLY/IPOLY)
• Fourier Source (/)
• Multidimensional Table Source (NDSRC)
• Power Source (P)
Voltage Source
>>Basics>Circuit>Sources
The component represents an independent voltage source. Within the dialog you can choose
a constant, or the time-controlled sine, pulse, triangular, trapezoidal, saw-tooth rising, or sawtooth
falling type.
Dialog Settings
� «EMF Value [V]»
The Linear Voltage Source is selected. Common parameter type. Enter a numerical value, a
variable, or an expression in the text box or use the pin to connect a quantity.
� � «Use pin»
If the box is checked, the EMF value is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
� � «Partial Derivation»
If the box is checked, the improved partial derivation algorithm is effective. In few cases,
when the source value is defined with a equation, instabilities are possible. Clear the box to
avoid the problem.