SIMPLORER User Manual V6.0 - FER-a

4
5
100 Modeling with Circuit Components
Component Outputs
Description [Unit] Parameter Name Data Type
Voltage [V] V real
Current [A] I real
EMF Value [V] (voltage source) EMF real
Source Current [A] (current source) IS real
Derivative of Voltage [V/s] dV real
Derivative of Current [A/s] dI real
Component Nodes
Description Node Name Nature
Pin 1 (with red point) N1 electrical
Pin 2 N2 electrical
Multidimensional Table Source
>>Basics>Circuit>Sources
The multidimensional table source represents a table of controlled electrical sources (voltage
and current) which depend on different, nonlinear input quantities. Each input quantity (node
voltage or current of ammeter) has a specific characteristic with extrapolation type. The characteristics
of input values can also be imported from a .mdx file created in the DAY Post Processor.
Eeach defined source has two pins, whereas pin 0 and pin 1 belong to the first source,
pin 2 and pin 3 to the seond source, an so on. Defined voltage sources have at the second pin
the red point (N2 of standard voltage sources), current sources have at the first pin the red
point (N1 of standard current sources).
vn [ ] () t = – f( v( QUANT)
[ m]
, i( QUANT)
[ m]
)
in [ ] () t =
f( v( QUANT)
[ m]
, i( QUANT)
[ m]
)
Dialog Settings
«Name»
Displays the component internal names of the input quantities which are defined in the
dialog. You cannot make changes in these fields.
«Input»
The voltage/current of the defined quantities control the values of the sources. Quantity parameter
type. The type accepts only a node potential or the current of an ammeters (e.g.
N0003.V , AM2.I). The values cannot be assigned by a variable. Enter the quantity or use the
pin to connect the quantity.
� � «Use pin»
If the box is checked, the control signal is defined by the quantity connected to the pin, otherwise
the name in the text box is used.