SIMPLORER User Manual V6.0 - FER-a

Transferring Parameter Values into Graphical Subsheets
SIMPLORER 6.0 — Manual 61
Two non-conservative input pins
To use mainsheet parameters in the subsheet you need non-conservative input pins. These
input pins are able to transfer a mainsheet quantity into the subsheet.
1 Choose SHEET>SUBSHEET OPEN to change into the subsheet wiring and choose «Create
Pin/Parameters…» on the subsheet shortcut menu.
2 Select Non-Conservative Node and define a name. Click to continue.
3 Select «Input» and click to continue.
4 Select the pin type. Please note: The type does not influence the parameter itself. It select
only a proper symbol which is displayed in the parameter dialogs.
Enter parameter type and
default value
5 Select the pin position. If you do not click any pin, you have to create the parameter transfer
with a name reference in the mainsheet.
6 The new pin symbol can now be connected with a parameter pin of a quantity in the subsheet.
When no connection is used you can enter the pin name to transfer the mainsheet
quantity.
7 Choose «Level Up» in the subsheet shortcut menu to change to the next higher model level.
Connect a mainsheet quantity with the pin or enter a name if the pin is disabled.