SIMPLORER User Manual V6.0 - FER-a

5
236 Modeling with Block Diagrams
«Channel Data»
Select an input signal in the list to define the corresponding characteristic data in the lookup
table. The name of the active input signal displays the group box inscription. Create, delete,
or move entries with the symbols placed on the upper right side. Click in the fields to enter
values. Please note, you cannot use variables or expressions. Only numbers are accepted.
� � «Sweep Data»
If the box is checked, you can sweep data for a given range of values. replaces the
values in the lookup table, inserts the new data at the table end.
Output Quantities
«Edit Output Channels»
Create or delete entries with the symbols placed on the upper right side. Each new output
signal represents a non-conservative node.
«Index»
Displays the component internal index of the input quantities. You cannot make changes in
these fields.
«Name»«Unit»
Click in the fields to define names and units for the corresponding output signal. Both are displayed
at the top of the columns in the lookup table and saved in the created .mdx file.
«Edit Output Data»
Click in the corresponding field to enter values for output signal. You can also use the
mode. Both views are automatically updated. Please note, you cannot use variables
or expressions. Only numbers are accepted.
Component Parameters
Description [Unit] Parameter Name Data Type
Input Signal INPUT[n] real
Table File Name FILE real
Interpolation Type IP real
Extrapolation Type EP[n] real
Sample Time [s} TS real
Simulator Outputs
Description [Unit] Parameter Name Data Type
Output Vector VAL[n] real
Derivative of Output Vector dVAL[n][m] real