SIMPLORER User Manual V6.0 - FER-a

SIMPLORER 6.0 — Manual 177
Electrical coupling of phase quantities with the orthogonal quantities
γ() t = p ⋅ ω() t dt
v1α() t
v1β() t
v1d() t
v1q() t
=
=
=
Dialog Settings
� «Parameters»
Click the «Value» field of the corresponding parameter to define a value. Common parameter
types. Enter a numerical value, a variable, or an expression. Look the meaning up in the parameter
table below.
� «Initial Values»
Click the «Value» field of the corresponding parameter to define the initial values. Common
parameter types. Enter a numerical value, a variable, or an expression. The values are set only
once at simulation start. Look the meaning up in the parameter table below.
� «Angular Dimension»
In the list, select radians or degrees for the angular dimension. The dimension is valid for all
angle input quantities in the machine model.
Component Parameters
Description [Unit] Parameter Name Data Type
Load Torque [Nm] LOAD real
Stator Resistance [Ω] R1 real
Stator Inductance d-Axis [H] L1D real
Stator Inductance q-Axis [H] L1Q real
Rotor Flux-linkage [Vs] KE real
Number of Pole Pairs [/] P real
Moment of Inertia [kg*m²] J real
Initial Current Stator Phase a [A] I1A0 real
Initial Current Stator Phase b [A] I1B0 real
Initial Current Stator Phase c [A] I1C0 real
Initial Rotor Speed [rpm] N0 real
Initial Rotor Position [deg] PHI0 real
Component Outputs
∫
2 1 1
--v
3 1a() t – --v
3 1b() t – --v
3 1c() t
3 3
------v
3 1b() t – ------v
3 1c() t
v1α() t ⋅ cos(
γt () ) + v1β() t ⋅ sin(
γt () )
= v1α() t ⋅ sin(
γt () ) – v1β ⋅ cosγ()
t
i1α() t = i1d() t ⋅ cos(
γt () ) – i1q() t ⋅ sin(
γt () )
i1β() t
= i1d() t ⋅ sin(
γt () ) + i1q() t ⋅ cos(
γt () )
i1a() t = i1α() t
i1b() t
1 3
= – --i
2 1α() t + ------i
2 1β() t
i1c() t
1 3
=
– --i
2 1α() t – ------i
2 1β() t
Description [Unit] Parameter Name Data Type
Rotor Speed [rpm] N real
Inner Torque [Nm] MI real