SIMPLORER User Manual V6.0 - FER-a

10
336 Physical Domains
Component Outputs
Description [Unit] Parameter Name Data Type
Temperature [K] T real
Heat Flow [J/s] H real
Component Nodes
Description Node Name Nature
Pin 1 (with red point) TH1 thermal
Pin 2 TH2 thermal
Time-Controlled Heat Flow Source
Ht () =
f[ time function]
The time controlled heat flow sources have the same properties as the linear heat flow source
above; the temperature can be arbitrary and the internal resistance is zero (ideal source). The
value of the flow rate instead is equivalent to the present value of the selected time function
at each calculation step.
The simulator internal names of time controlled flow sources read as follows: Sine – HSINE;
Pulse – HPULSE; Triangular – HTRIANG; Trapezoidal – HTRAPEZ; Saw-tooth Rising –
HSZ_RISE; Saw-tooth Falling – HST_FALL. The names are only relevant to simulation scripts
in SML. Access to source parameters is carried out only by the component name.
Component Parameters
Description [Unit] Parameter Name Data Type
Amplitude [J/s] AMPL real
Frequency [Hz] (no trapezoidal function parameter) FREQU real
Period [s] TPERIO real
Delay [s] TDELAY real
Phase [deg] PHASE real
Angular Dimension n/a
Offset OFF real
Periodical; PERIO=1, periodical function, PERIO=0; non-periodical
function
PERIO real
Damping factor [1/s] (only sine function)
DAMPING>0, amplitude is exponentially decreasing
(damped). DAMPING