SIMPLORER User Manual V6.0 - FER-a

4
5
182 Modeling with Circuit Components
Dialog Settings
� «Parameters»
Defines the machine parameters in the table. Common parameter types. Enter a numerical
value, a variable, or an expression in the text box. Look the parameter meaning up in the parameter
table below.
� «Initial Values»
Defines the initial values of the machine in the table. Enter a numerical value, a variable, or
an expression in the text box to define the initial values at simulation start. Look the parameter
meaning up in the parameter table below.
� «Angular Dimension»
Select the angular dimension – radians or degrees – in the list. The dimension is valid for all
angle input quantities in the machine model.
Component Parameters
Description [Unit] Parameter Name
Load Torque [Nm] LOAD real
Armature Resistance [Ω]
Sum of resistances of all windings of armarture circuit
RA real
Armature Inductance [H]
Sum of inductivities of all windings of armarture circuit
LA real
Rotor Flux Linkage [Vs] KE real
Moment of Inertia [kg*m²] J real
Initial Armature Current [A] IA0 real
Initial Rotor Speed [rpm] N0 real
Initial Rotor Position [deg] PHI0 real
Component Outputs
Description [Unit] Parameter Name
Rotor Speed [rpm] N real
Inner Torque [Nm] MI real
Rotor rational Speed [1/s] OMEGA real
Angular Rotor Acceleration [1/s²] ALPHA real
Rotor Angle in Radians [rad] PHI real
Rotor Angle in Degrees [deg] PHIDEG real
Armature Voltage [V] VA real
Armature Current [A] IA real
Linked Armature Flux [Vs] PSIA real
1st derivative Armature Voltage [V/s] dVA real
1st derivative Armature Current [A/s] dIA real
1st derivative linked Armature Flux [V] dPSIA real
Component Nodes
Description Node Name Nature
Armature Node N1 (with red point) and N2 N1/N2 electrical