SIMPLORER User Manual V6.0 - FER-a

4
5
102 Modeling with Circuit Components
� � «Sweep Data»
If the box is checked, you can sweep data for a given range of values. replaces the
values in the lookup table, inserts the new data at the table end.
Output Quantities
«Edit Output Channels»
Create or delete entries with the symbols placed on the upper right side. Each new source has
two conservative nodes (pins). The first source has pin 0 and 1, the second source 2 and 3, …
«Index»
Displays the component internal index of the output quantities. You cannot make changes in
these fields.
«Name»«Unit»
Click in the fields to define names and units for the corresponding input quantity. Both are
displayed in the column headings of the lookup table and saved in the created .mdx file.
«Edit Output Data»
Click in the fields to enter values for corresponding output sources. You can also use the
mode. Both views are automatically updated. Please note, you cannot use variables
or expressions. Only numbers are accepted.
Component Parameters
Description [Unit] Parameter Name Data Type
Table File Name P real
Interpolation Type IP real
Control Input QUANT[n] real
Extrapolation Type EP[n] real
Source Type SRC[n] real
Component Outputs
Description [Unit] Parameter Name Data Type
Output Vector SRC_QUANT[n] real
Derivative of Output Vector dSRC_QUANT[n][m] real
Component Nodes
Description Node Name Nature
First Source N0 N1 electrical
Second Source N2 N3 electrical