SIMPLORER User Manual V6.0 - FER-a

SIMPLORER 6.0 — Manual 283
«Delay [s]»
Defines the initial delay of the saw-tooth function. Common parameter type. Enter a numerical
value, a variable, or an expression in the text box.
«Phase [deg]»
Defines the phase shift of the saw-tooth function. Common parameter type. Enter a numerical
value, a variable, or an expression in the text box.
� «Angular Dimension»
In the list, select radians or degrees. The dimension is applied to the phase.
«Offset»
Defines the Y shift of the saw-tooth function. Common parameter type. Enter a numerical value,
a variable, or an expression in the text box.
� «Periodical»
In the list, select «Yes» for a periodical saw-tooth function; select «No» for carrying out only
one period corresponding to the defined frequency. After them the saw-tooth function is '0'.
Click the button to display the saw-tooth function with the defined values. Please note: If you
use variables for the definition, the preview is empty.
Component Parameters
Description [Unit] Parameter Name Data Type
Frequency [Hz] FREQ real
Period [s] TPERIO real
Amplitude AMPL real
Phase [deg] PHASE real
Periodical PERIO real
Offset OFF real
Initial Delay [s] TDELAY real
Component Outputs
Description [Unit] Parameter Name Data Type
Saw-tooth Function VAL real
Derivative of Saw-tooth Function dVAL real