SIMPLORER User Manual V6.0 - FER-a

Symbol Management
File Menu �
SIMPLORER 6.0 — Manual 501
You can load symbols when you start the Symbol Editor or within the Symbol Editor from the
model tree. If you load symbols with drag-and-drop from the model tree, you have three options:
• Load the selected symbol into a new window (drop the element into the toolbar or the
symbol edit window)
• Add the selected symbol to an existing symbol (drop the element into the symbol window
by holding down the CTRL key).
• Replace the active symbol in the edit window with the selected symbol (drop the element
into the symbol window by holding down the ALT key)
�
�
�
Open a new edit window.
Add to an existing
symbol by holding down
CTRL key
Replace an existing
symbol by holding
down the ALT key
(Apart from the pins)
The FILE>SAVE menu command applies changes to symbol properties. The changes are effective
if the symbol is dropped onto the Schematic sheet now. Components already existing in
an opened simulation model in the Schematic can be updated with «Synchronize» on the
components’s shortcut menu.
Command Toolbar Symbol and Description
CLOSE Closes the active symbol with the prompt to save, if changes
were made to the last saved version.
SAVE Saves the active symbol, including all settings.
SAVE ALL Saves all symbols open in the Symbol Editor.
SAVE AN GO BACK Saves the active symbol and goes to the program started the
Symbol Editor, for example the Schematic.
PROJECT Switches to the SSC Commander window.
EXIT Closes the Symbol Editor, prompting you to save if symbols are
still open.
�
�
�
�