SIMPLORER User Manual V6.0 - FER-a

5
210 Modeling with Block Diagrams
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Delay
Component Parameters
Description [Unit] Parameter Name Data Type
Number of Samples (for separate initial values) NH real
Initial Values (for separate initial values) Y0[n] real
File with Initial Values (for initial values defined in a file) FILE file
Input Signal INPUT real
Sample Time [s] TS real
Component Outputs
Description [Unit] Parameter Name Data Type
Block output signal VAL real
>>Basics>Blocks>Continuous Blocks
The block represents a delay time of the input signal with a defined number of samples. The
delay is specified as simulation time.
yt () = xt ( – TD)
TD = NH ⋅ [ t( k – 1)
– tk ( ) ]
TD = Delay Time NH =
Samples
Dialog Settings
«Delay Time»
Defines the delay time in seconds. Enter a numerical value (non-negative integer with or
without unit suffix) in the text box to define the delay time. Please note: You cannot define a
variable or expression in this case. Only a number is accepted.
«Samples»
Defines the number of samples within the delay time. Enter a numerical value (non-negative
integer with or without unit suffix) in the text box to define the samples. Please note: You cannot
define a variable or expression in this case. Only a number is accepted.
Defines the values for t