SIMPLORER User Manual V6.0 - FER-a

Component Outputs
5.4 Signal Processing
• Maximum of Input Signals (MAX)
• Minimum of Input Signals (MIN)
• Summation (SUM)
• Multiplier (MUL)
• Negator (NEG)
• Limiter (LIMIT)
• Comparator (COMP)
• Two-Point Element with Hysteresis (TPH)
• N-Point Element (NP)
• Discretization Element (DIS)
• Nonlinear Characteristic (NL)
• Equation Block (FML)
• Maximum/Minimum Value at Time T (MAXT/MINT)
• Multidimensional Table Block (NDNL)
Maximum of Input Signals
SIMPLORER 6.0 — Manual 221
Description [Unit] Parameter Name Data Type
Block output signal VAL real
Magnitude AC Analysis AC_MAG real
Phase Shift AC Analysis [deg] AC_PHASE real
>>Basics>Blocks>Signal Processing
The block provides the maximum value from all input signals at each time step at the block
output. The component cannot be used with AC and DC simulation.
yk ( ) =
Max( x1( k)
, x2( k)
, …, xn( k)
)
Dialog Settings
«Input Signals»
Create, delete, or move entries of input signals with the symbols placed on the upper right
side. Please note: If you need more than the available places for pins at the symbol, clear the
«Use Pin» box and type the name in the «Input Signal» text box. See also “Defining Parameters”
on page 49.
«Name»
Displays the name of the input signals. If you click the index name, you can modify the number
(non-negative integer). Please note: You cannot define a index twice.
«Info»
User specific field to enter information about an input signal. Click the field of the corresponding
input signal and enter the text. You can display these information on the sheet by defining
the display setting within the block output dialog. See also “Defining Displays and Outputs”
on page 51.