SIMPLORER User Manual V6.0 - FER-a

12
388 Simulation Results
Data Tab
Don’t Clear Data Cache at Program End
Online simulation data are available via the View Tool only while the View Tool is active.
However, the «Restart external View Tool» option reopens the last View Tool used, including
its simulation data. To restore the data, the option «Do not clear data cache at the program
end» in the View Tool menu OPTIONS>SETTINGS «Data» must be checked. During the
simulation View Tool writes the data into the temporary Windows directory. Usually these
data will be deleted when you close SIMPLORER. Using the «Do not clear...» option, the data
will remain on the hard disk and are available to be saved in a file until another simulation is
started.
All simulation data (even the online outputs) will be kept. Start the View Tool in the SSC Commander
and choose FILE>RELOAD LAST SIMULATION and the latest data are available immediately,
without a new simulation.
12.3.2 Editing Data Channels and Diagram Settings
Edit Menu �
View Tool data file is kept on hard disk
The simulation results are presented first in the form defined in the .sml source file. With the
View Tool you can change this presentation later. The edit commands for data channels are
available in the EDIT menu and in the shortcut menu of a graphic. Most of them can also be
selected from symbols in the toolbar.
Command Toolbar Symbol and Description
COPY Copies the window contents to the clipboard as a bitmap.
EDIT CHANNEL Opens a shortcut menu to edit a data channel. See also “Shortcut
Menu for Data Channels” on page 389.
ADD/REMOVE
CHANNELS
EDIT COORDINATE
SYSTEM
Opens a dialog box to select data channels.
Defines the coordinate system settings for the coordinate system
in the active graphic window. The options are available for both
the X- and Y-axis. Linear or logarithmic, Scaling factors, Reset to
simulator defaults. See also “Editing Diagram Settings” on page
391.
RESET Sets the coordinate system to the original TEND and YMIN/
YMAX adjustments.