SIMPLORER User Manual V6.0 - FER-a

14
444 Data Evaluation
Window
Select the window used for the FFT calculation.
Start the computation.
Close the FFT dialog without saving.
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
Select simulation data
Set Time window
Set amplitude filter
Set% for maximum amplitude
Select the format of the result (absolute
value & phase or real & imaginary part)
Select the format of the result (absolute
value & phase or real & imaginary part)
Select Graphical or tabular representation
of FFT in the new window
Start calculation
After you click , only the amplitude spectrum is displayed. Phase (deg or rad)
and proportional evaluation for amplitudes must be displayed separately.
When the computation is finished, close the FFT dialog. The results are displayed in the background.
If you do not close the FFT dialog, you cannot perform any other function.