SIMPLORER User Manual V6.0 - FER-a

3
5
60 General Modeling Functions
5 Change to the main sheet («Level Up» in the subsheet shortcut menu) and check the connections
and parameters of the subsheet.
Marked components in the main sheet
As in the variant above, the subsheet is considered a normal system component. To edit the
subsheet, select the symbol, and then choose «Open» on the shortcut menu or choose SUB-
SHEET>OPEN.
State Graphs in Graphical Subsheets
� � �
Components in
the subsheet Subsheet in the main sheet
The input and output definitions in state graph structures in subsheet differs from the circuit
(conservative nodes) and block diagram (input and output parameters).
If you want to create a state graph where transitions represent the subsheet edge, you must
use two non-conservative output pins in the subsheet. Create two output pins and connect
them with the state graph structure which starts with a state component.
Two non-conservative output pins
If you want to create a state graph where states represent the subsheet edge, you must use
two non-conservative input pins in the subsheet. Create two input pins and connect them
with the state graph structure which starts with a transition component.