SIMPLORER User Manual V6.0 - FER-a

Component Parameters
8.4 Special Waveform Parameters
• Mean Value (MEAN)
• RMS Value (RMS)
• Sliding Mean Value (MEAN_SLD)
• Sliding RMS Value (RMS_SLD)
• Power and Energy (POWER)
• FFT (FFT)
Mean Value
SIMPLORER 6.0 — Manual 267
Description [Unit] Parameter Name Data Type
Input Signal (Second reference signal, actual value) INPUT real
Setpoint (First reference signal, setpoint) SETVAL real
Component Outputs
Description [Unit] Parameter Name Data Type
Deviation DEV real
Integral Absolute Error IAE real
Integral Squared Error ISE real
Integral Time Absolute Error ITAE real
Integral Time Squared Error ITSE real
>>Basics>Signal Characteristics>Special Waveform Parameters
The macro provides the mean value of a variable for a given interval. The TSTART and TSTOP
parameters can be modified (mostly periodically) by variable assignments. So after each signal
period an active mean value is available. The beginning and end time of maximum/minimum
determination TSTART and TSTOP have to be within'0' and the simulation end time
TEND.
N
1
MEAN = --- ⋅ x
N ∑ k N = Number of time step
k = 1
INPUT = x VAL =
MEAN
Dialog Settings
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.