SIMPLORER User Manual V6.0 - FER-a

SIMPLORER 6.0 — Manual 217
� «Filter Type»
In the list, select Low Pass, High Pass, Band Pass, or Band-Stop type.
«Order»
Defines the filter order. Enter a numerical value (non-negative integer with or without unit
suffix) in the text box. Please note: You cannot define a variable or expression in this case.
Only a number is accepted.
«Cut-Off Frequency»
Defines the cut-off frequency (Band Pass type has a lower and upper). Enter a numerical value
(non-negative integer with or without unit suffix) in the text box. Please note: You cannot define
a variable or expression in this case. Only a number is accepted.
� «Sample Time»
Enter a numerical value, a variable, or an expression in the text box or use the pin to connect
a quantity. Please note: The sample time must be a positive value.
� � «Use Pin»
If the box is checked, the sample time is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Component Parameters
Description [Unit] Parameter Name Data Type
Dimension of Numerator N real
Dimension of Denominator D real
Numerator Coefficients Q[n) real
Denominator Coefficients P[n] real
Input Signal INPUT real
Sample Time [s] TS real
Component Outputs
Description [Unit] Parameter Name Data Type
Block output signal VAL real