SIMPLORER User Manual V6.0 - FER-a

Negator
SIMPLORER 6.0 — Manual 225
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
� «Sample Time»
Select «System» for simulator-defined variable sample time. Select «Value» to define a numerical
value, a variable, or an expression in the text box or use the pin to connect a quantity.
Please note: The sample time must be a positive value.
� � «Use Pin»
If the box is checked, the sample time is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Component Parameters
Description [Unit] Parameter Name Data Type
Input Signal INPUT[n] real
Sample Time [s] TS real
Component Outputs
Description [Unit] Parameter Name Data Type
Block output signal VAL real
>>Basics>Blocks>Signal Processing
The block multiplies the input signal at each time step with -1 and provides the result at the
block output.
yk ( ) =
– xk ( )
Dialog Settings
� «Sample Time»
Select «System» for simulator-defined variable sample time. Select «Value» to define a numerical
value, a variable, or an expression in the text box or use the pin to connect a quantity.
Please note: The sample time must be a positive value.
� � «Use Pin»
If the box is checked, the sample time is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.