SIMPLORER User Manual V6.0 - FER-a

Component Outputs
Voltage Controlled Oscillator
SIMPLORER 6.0 — Manual 95
Description [Unit] Parameter Name Data Type
Voltage [V] V real
Current [A] I real
Derivative of Voltage [V/s] dV real
Derivative of Current [A/s] dI real
Component Nodes
Description Node Name Nature
Pin 1 (with red point) N1 electrical
Pin 2 N2 electrical
>>Basics>Circuit>Sources
The component represents a voltage controlled Oscillator. Within the dialog you can choose
a voltage or current source.
Dialog Settings
� «Type»
In the list, select the Voltage or Current Source.
� «Limit Input Voltage»
Each value of the input voltage, which controls the frequency of the voltage/current source,
is accepted.
� «Limit Input Voltage»
If the box is checked, you can enter an upper and lower limit in the corresponding text box.
Values outside of the range are ignored.
«Upper Limit»/«Lower Limit»
Common parameter type. Enter a numerical value, a variable, or an expression in the text box
or use the pin to connect a quantity.
«Output Amplitude»
The value defines the amplitude of the sine wave. Common parameter type. Enter a numerical
value, a variable, or an expression in the text box or use the pin to connect a quantity.
«Phase»
Phase shift of the created sine wave. Common parameter type. Enter a numerical value, a
variable, or an expression in the text box or use the pin to connect a quantity.
� «Angular Dimension»
In the list, select radians or degrees for the angular dimension. The dimension is valid for all
angle input quantities in the VCO model.
� � «Spice Compatible»
If the box is checked, the spice compatible reference arrow system is applied to the source.