SIMPLORER User Manual V6.0 - FER-a

Sliding Mean Value
SIMPLORER 6.0 — Manual 269
Start Time [s] TSTART real
Stop Time [s] TSTOP real
Component Outputs
Description [Unit] Parameter Name Data Type
RMS Value VAL real
>>Basics>Signal Characteristics>Special Waveform Parameters
The C Model provides the sliding mean value of a variable. The value is calculated within the
user-defined time-window of the length TMEAS. The beginning and end time of value determination
TSTART and TSTOP have to be within'0' and the simulation end time Tend. TMEAS
should be the ten times the maximal simulation time step HMAX.
MEAN SLD
1
= -------------------- ⋅ INPUT() t dt
TMEAS ∫
TSTART ≤t≤( TSTOP – TMEAS)
Dialog Settings
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Start Time [s]»«Stop Time [s]»
Common parameter type. Enter a numerical value, a variable, or an expression in the text box.
The specified start time (for beginning of calculation) has to be less than the end time (for end
of calculation).
� «Sample Time»
Select «System» for simulator-defined variable sample time. Select «Value» to define a numerical
value, a variable, or an expression in the text box or use the pin to connect a quantity.
Please note: The sample time must be a positive value.
� � «Use Pin»
If the box is checked, the sample time is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Component Parameters
t+ TMEAS
t
Description [Unit] Parameter Name Data Type
Input Signal [/] INPUT real
Start Time [s] TSTART real
Stop Time [s] TSTOP real
Integration Period [s] TMEAS real