SIMPLORER User Manual V6.0 - FER-a

8
264 Using Signal Characteristics
For time definitions refer to the following figure:
SETVAL+TOLERANCE
SETVAL
SETVAL-TOLERANCE
Dialog Settings
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Setpoint Value»
Defines the setpoint of the input signal. Common parameter type. Enter a numerical value, a
variable, or an expression in the text box.
«Tolerance»
Defines the tolerance band around the setpoint (setpoint±tolerance). Common parameter
type. Enter a numerical value, a variable, or an expression in the text box.
«Start Time [s]»«Stop Time [s]»
Common parameter type. Enter a numerical value, a variable, or an expression in the text box.
The specified start time (for beginning of calculation) has to be less than the end time (for end
of calculation).
Component Parameters
Description [Unit] Parameter Name Data Type
Input Signal INPUT real
Setpoint SETVAL real
Tolerance TOLERANCE real
Start Time [s] TSTART real
Stop Time [s] TSTOP real
Component Outputs
TDEAD
TSTART
TRISE
TSETTLING
TSTOP
t [s]
Description [Unit] Parameter Name Data Type
Dead Time [s] TDEAD real
Rise Time [s] TRISE real
Settling Time [s] TSETTLING real