SIMPLORER User Manual V6.0 - FER-a

5
232 Modeling with Block Diagrams
� � «Use Pin»
If the box is checked, the sample time is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Component Parameters
Description [Unit] Parameter Name Data Type
Characteristic CH real
Input Signal INPUT real
Sample Time [s] TS real
Component Outputs
Description [Unit] Parameter Name Data Type
Block output signal VAL real
Equation Block
>>Basics>Blocks>Signal Processing
The block provides a numerical links between input signals and block intern variables at the
block output.
ym ( ) = fxn ( ( ) , xn ( – 1)
, …, var1, var2, …)
ym ( ) = VAL( m)
x( n)
=
INPUT( n)
Dialog Settings
«Name»
Displays the number of the input signals. If you click the index name, you can modify the
number (non-negative integer). Please note: You cannot define a index twice.
«Input Signals»
Create, delete, or move the entries of input signals with the symbols placed on the upper right
side. Please note: If you need more than the available places for pins at the symbol, clear the
«Use Pin» box and type the name in the «Input Signal» text box. See also “Defining Parameters”
on page 49.
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Type»
Create, delete, or move entries of block intern variables or output signals with the symbols
placed on the upper right side. Please note: The variables defined within the block cannot be
used for other components. See also “Defining Parameters” on page 49.