SIMPLORER User Manual V6.0 - FER-a

9
286 Modeling Tools
Delay within the Period [s] T0 real
Periodical PERIO real
Offset OFF real
Initial Delay [s] TDELAY real
Component Outputs
Description [Unit] Parameter Name Data Type
Needle Pulse Function VAL real
Controlled Oscillator
>>Basics>Tools>Time Functions
yt () = AMPL ⋅ sin(
360° ⋅ f + PHASE)
f = fCTRL ( )
f = UL when UL< CTRL
f = LL when LL> CTRL
Dialog Settings
� «Limit Input Signal»
Each value of the input signal, which controls the frequency of the output signal, is accepted.
� «Limit Input Signal»
If the box is checked, you can enter an upper and lower limit in the corresponding text box.
Values outside of the range are ignored.
«Upper Limit»«Lower Limit»
Common parameter type. Enter a numerical value, a variable, or an expression in the text box.
«Output Amplitude»
Defines the amplitude of the sine wave. Common parameter type. Enter a numerical value, a
variable, or an expression in the text box.
«Phase»
Defines the phase shift of the sf the created sine wave. Common parameter type. Enter a numerical
value, a variable, or an expression in the text box.
«Angular Dimension»
In the list, select radians or degrees. The dimension is applied to the phase.
Component Parameters
Description [Unit] Parameter Name Data Type
Input Signal CTRL real
Input Signal Upper Limit UL real
Input Signal Lower Limit LL real
Amplitude AMPL real
Phase [deg] PHASE real